Wolverine Heaters Engine Oil Pre Heater - 6 X 10.75 Inch (1000W), 230v

Name: Wolverine Heaters Engine Oil Pre Heater - 6 X 10.75 Inch (1000W), 230v
Brand: Wolverine Heaters
Price: 250.72 GBP
Availability: InStock

The Wolverine Engine Oil Pre Heater is a game-changer in the world of car enthusiasts. This innovative solution provides a simple yet highly effective way to preheat engine oil before initial start-up, ensuring improved cold starting, reduced cold start wear, and faster full operating temperature. The low-profile heater pads are designed using aerospace technology, making them easy to fit onto your sump pan or dry sump tank via the 'peel and stick' highly adhesive backing. The Wolverine pre-heater can raise the oil to near-full operating temperature in just 45-90 minutes, depending on ambient temperature. The benefits of this cutting-edge solution are numerous: * Improved cold starting: less strain on starter motor and battery * Reduced cold start wear * Immediate lubrication * Reduced emulsification in the oil * Faster full operating temperature To install the Wolverine pre heater pads, follow these simple steps: 1. Wire the cable to a suitable plug (see wiring information below). 2. Mark the area where the pad is to be fitted, ensuring it's large enough to accommodate the full area of the pad. 3. Clean the area by removing any paint, grease, oil, or other contaminants using acetone or brake cleaner. 4. Remove the backing from the pad and apply the heater for 3-5 minutes to warm it up. 5. Apply the heater pad to the cleaned area, removing any air pockets using the supplied application tool. 6. Plug in the heater for 5-10 seconds, then smooth over to remove any remaining air bubbles. 7. Seal the edges of the pad using the supplied silicone sealer and allow the sealant to fully cure before operating the heater. The kit includes: * Silicone heater pad with 6ft long cable * Pad applicator tool * Silicone sealer * Cable ties for the cord * Instructions Wolverine Engine oil pre-heaters are available in a range of sizes to suit many different applications. Please use the table below to select the correct option for your application. The Wolverine heaters come in 12v DC, 24v DC, and 230v/240v options. They are supplied with bare wire ends and require wiring. The 12v DC and 24v DC versions have 2 wires and are not polarity sensitive, so they can be wired either way. For the 230v/240v option, a 13amp plug is required (not included). For wiring purposes, the centre wire (green/yellow) is wired to earth pin, and the other two wires are to live and neutral. If you're unsure about how to wire, please call for further assistance. The Wolverine Engine Oil Pre Heater is available in various sizes to suit different applications.

Current Lowest Price

GBP 250.72

VISIT SITE

Wolverine Heaters Engine Oil Pre Heater - 6 X 10.75 Inch (1000W), 230v

PRODUCT DATA

SellerDemon Tweeks
BrandWolverine Heaters
CategoryEngine Pre Heaters
ConditionNew
Stock StatusIn Stock
Part Number3400095
Delivery Time1 to 4 days
Delivery Cost6.95

Wolverine Heaters Engine Oil Pre Heater - 6 X 10.75 Inch (1000W), 230v

PRODUCT DATA

PRICE HISTORY

RELATED PRODUCTS

About CP

Buying

Selling

Small Print

FOLLOW

Seller	Demon Tweeks
Brand	Wolverine Heaters
Category	Engine Pre Heaters
Condition	New
Stock Status	In Stock
Part Number	3400095
Delivery Time	1 to 4 days
Delivery Cost	6.95